DIRECTIONS FOR USE:

Mold Preparation: When using the Composi-Stone Mix in a Composi-Mold, make sure the Composi-Mold is completely cooled to room temperature or lower prior to use. Use a mold release that works with plaster or cement (Composi-Mold's Vegetable-Oil Mold Release works great).

Mixing: Measure between 2-2.5 parts dry mix to 1 part water, by volume, into a mixing container such as a plastic cup or bucket. For better accuracy, the components can be weighed. The mixing ratio, by weight, is 2 parts mix to 1 part water. Start mixing immediately and be sure to scrape the material off the sides of the mixing container. Mix until all parts are mixed up and there are little to no lumps.

Pouring: After thorough mixing, pour the mix into the Composi-Mold mold cavity. Using a ratio of 2:1 by volume will result in an easier pour, but a longer cure time.  The Composi-Stone will begin to cure and solidify within 5 to 10 minutes depending on the temperature and the amount of water that was used. Wait approximately 3-4 hours before removing the part from the Composi-Mold mold. Less time may deform the part.

Cleaning: To improve clean up after using the Composi-Stone Mix, rub some Vegetable-Oil Mold Release on the mold. Tools and equipment should be scraped clean prior to the mix curing and hardening.

Safety: The powder may cause eye, skin, dermal, and respiratory sensitization. Avoid contact with skin and eyes. Use in a well ventilated area or wear a dust mask while mixing. If skin contact occurs, remove with soap and water. In case of eye contact, flush with water for 15 minutes and seek physician support. Material Safety Data Sheets (MSDS) are always available be emailing [email protected].

Product Safety

This product is subject to specific safety warnings

Warning: Not suitable for children under 8 years. For use under adult supervision.